Tuesday, September 21, 2010
I hold installed a not easy drive(no.2) into my comp and its on slave but no deity is contained by my computer?
I hold installed a not easy drive(no.2) into my comp and its on slave but no deity is contained by my computer?
did you craft sure you changed the jumpers on both your HD's to cable select or one to master and the other to slave?
i believe default on most hd's if cable select if you changed your 2nd one to slave and didn't switch you 1st to master that may be your problem
Make sure the first one has a pullover and set to master!
This depends on the Hard drive's manufacturing company. Having multiple easier said than done drives is sometimes a lame thing because sometimes conflicts crop up if you misinstalled or misused the hard drive.
Good luck
Make sure you changed the jumper on both your Hard Disk to cable select or one to master and the other to slave.
The required jumper setting vary from Hard Disk to Hard Disk. It is clearly mentioned on the Hard Disks. So I wish you will know how to configure that. Then get into your BIOS and check the IDE Setting where on earth you can see which hard disk is configured as master and which is configured as slave. If everything is displayed as you want later fine. Otherwise you are doing mistakes on jumper configuration.
Did you format the HDD? if it's not formatted, it won't show! Make sure you create an alive partition past formatting.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment